Bride Transfer – Rhinestone

Preparation

• Check your iron, STEAM OFF!
• Preheat iron to the cotton setting
• Position your garment on your ironing board. If you can place something sturdy underneath like a wood board, it will help with the pressure needed for proper application.
• Carefully peel the white film backing off the transfer. 
• Confirm that that all of the transfer’s rhinestones are in the proper position and orientation
• If any rhinestones are out of alignment, simply push them into place with tweezers.
• Place the transfer, in the desired location, with the clear tape facing up, glue side down on your garment. If it is not in the desired position, lift and reposition. Press into place with your hand.

Press the Transfer

• To protect your fabric from your hot iron, we recommend that you put a light covering cloth over the transfer before ironing.
• Place iron over the design area and apply steady pressure for 15 seconds (DO NOT MOVE IRON AROUND AS STONES MAY SHIFT) Place iron over another design area for another 15 seconds and repeat till entire design is pressed. (Do not overheat or glue will lose its adhesion).

Finishing 

• When all areas of the transfer have been pressed, slowly peel off your tape, If you have missed any areas, go back and re-press.
• For best care, wash garment inside out in cold delicate cycle & hang dry.